Ice-O-Matic GEM0650R Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Les fabricants de glaçons Ice-O-Matic GEM0650R. Ice-O-Matic GEM0650R User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Ice-O-Matic
11100 East 45th Ave
Denver, Colorado 80239
Part Number 9081350-02 17-3144-01 Date 10/08
SERVICE AND INSTALLATION MANUAL
GEM Models: Remote
GEM0650R, GEM0956R, GEM1256R
Pearl IceSeries
By Ice-O-Matic
Vue de la page 0
1 2 3 4 5 6 ... 49 50

Résumé du contenu

Page 1 - GEM0650R, GEM0956R, GEM1256R

Ice-O-Matic11100 East 45th AveDenver, Colorado 80239Part Number 9081350-02 17-3144-01 Date 10/08SERVICE AND INSTALLATION MANUALGEM Models: RemoteGEM

Page 2

GEM0650/0956/1256 Remote For the Installer Page 4 Bin Application The Pearl Ice™ Series are designed to fit the following Ice-O-Matic Bins ●B42,

Page 3

GEM0650/0956/1256 Remote For the Installer Page 5 Location: Ice-O-Matic ice machines are designed to be installed indoors in a controlled environ

Page 4

GEM0650/0956/1256 Remote Remote Condenser Page 6 ERC Dimensions (Inches) GRC1001 GRC1061 GCR2061 A 33.36 33.36 33.36 B 10.75 1

Page 5 - Important!

GEM0650/0956/1256 Remote Remote Condenser Location Page 7 Use the following for planning the placement of the remote condenser relative to the ic

Page 6 - Page iv

GEM0650/0956/1256 Remote For the Installer Remote Condenser Location: Limited to a 25 foot or a 40 foot length of precharged refrigerant tubing co

Page 7

GEM0650/0956/1256 Remote For the Installer Page 9 Typical Installation REMOTE CONDENSER ICE MACHINE

Page 8 - GEM0650/0956R

GEM0650/0956/1256 Remote For the Installer Page 10 Coupling Instructions: Initial Connections: 1. Remove the protector caps and plugs. Wipe the

Page 9 - GEM1256R

GEM0650/0956/1256 Remote For the Plumber Page 11 Water Inlet: The recommended water supply is cold water. Use 3/8 inch O.D. copper tubing, conne

Page 10

GEM0650/0956/1256 Remote For the Electrician Page 12 INSTALLATION MUST CONFORM TO ALL APPLICABLE CODES. Connect the electrical power to the unit

Page 11

GEM0650/0956/1256 Remote For the Installer Page 13 Completed Installation A typical installation should generally appear as illustrated below.

Page 13

GEM0650/0956/1256 Remote For the Installer Page 14 Final Check List Roof Holes Sealed? Condenser Leveled? ___1. Is the ice system installed indo

Page 14

GEM0650/0956/1256 Remote Start Up Page 15 Pre-Start Inspection: 1. Remove the front and side service panels. 2. Check that any shipping blocks

Page 15 - Typical Installation

GEM0650/0956/1256 Remote Component Description Page 16 ●Control Box: Contains the electrical controls that operate the machine. ●High Pressure Cu

Page 16

GEM0650/0956/1256 Remote Component Description Page 17 ●Contactor: A definite purpose contactor connecting the compressor and the fan motor to t

Page 17

GEM0650/0956/1256 Remote Component Description Page 18 ●Evaporator: A refrigerated vertical tube filled with water and containing a water seal a

Page 18

GEM0650/0956/1256 Remote Electrical Sequence Page 19 Electrical Sequence: There are 7 indicator lights on the control board: ●WTR-OK: (Water OK

Page 19 - Page 13

GEM0650/0956/1256 Remote Operation: Water Page 20 Water Water enters the machine through the 3/8 inch male flare at the rear of the cabinet, goes

Page 20 - Page 14

GEM0650/0956/1256 Remote Operation: Refrigeration Page 21 Beginning at the compressor, the refrigerant is compressed into a high temperature gas.

Page 21

GEM0650/0956/1256 Remote Operation: Refrigeration Page 22 Low Condensing Temperature The refrigeration system under low condenser air temperature

Page 22

GEM0650/0956/1256 Remote Operation: Refrigeration Page 23 Pump Down During the pump down cycle (usually initiated by the circuit board de-energiz

Page 23 - Control Board

GEM0650/0956/1256 Remote Introduction Page i How To Use This Manual Ice-O-Matic provides this manual as an aid to the end user and service techni

Page 24

GEM0650/0956/1256 Remote Operation: Performance Page 24 Typical Low Side Pressure: Remote: 34-38 PSIG Typical Discharge Pressure: Remote:

Page 25

GEM0650/0956/1256 Remote Sanitizing and Cleaning Page 25 It is the USER’S RESPONSIBILITY to keep the ice machine and ice storage bin in a sanitar

Page 26

GEM0650/0956/1256 Remote Condenser Maintenance Page 26 ● Clean the condenser: the condenser may appear to be clean on the surface, but it can st

Page 27

GEM0650/0956/1256 Remote Bearing Maintenance Page 27 Bearing Maintenance: The bearing in the breaker should also be checked at least two (2) times

Page 28

GEM0650/0956/1256 Remote Sensor Maintenance Page 28 Bin Control Sensor: Ice Discharge Chute The bin control uses devices that sense light, therefo

Page 29

GEM0650/0956/1256 Remote Auger Maintenance Page 29 Auger: In some areas, the water supply to the ice machine will contain a high concentration of

Page 30

GEM0650/0956/1256 Remote Service Diagnosis Page 30 Symptom Possible Cause Probable Correction No ice is made nothing operates. •Unit off d

Page 31

GEM0650/0956/1256 Remote Service Diagnosis Page 31 Symptom Possible Cause Probable Correction Unit makes ice, but very slowly •High disc

Page 32 - Brush in direction of fins

GEM0650/0956/1256 Remote Control System Diagnostics Page 32 The Control System consists of: ●Control Board ●Water Sensors ●Ice Sensors ●High Pres

Page 33 - . Unscrewing the auger stud

GEM0650/0956/1256 Remote R&R- Water Reservoir, Bin Control Page 33 Water Reservoir: 1. Disconnect electrical power supply. 2. Shut off wat

Page 34

GEM0650/0956/1256 Remote Table Of Contents Page ii Table of Contents Introduction...

Page 35

GEM0650/0956/1256 Remote R&R-Bearing and Breaker Page 34 Note: Removal of the auger, water seal, evaporator and gear motor must begin at the

Page 36 - Page 30

GEM0650/0956/1256 Remote R&R-Auger Page 35 To Remove the Auger: 1. Disconnect electrical power. 2. Turn off the water to the machine. 3. Unc

Page 37 - Page 31

GEM0650/0956/1256 Remote R&R-Water Seal Page 36 To Remove the Water Seal: (Assuming all steps to remove the auger have been performed) 1. Th

Page 38

GEM0650/0956/1256 Remote R&R-Evaporator Page 37 To Replace the Evaporator: (Assuming all steps for removal of the thrust bearing, breaker, a

Page 39

GEM0650/09561256 Remote R&R-Gear Motor To Check the Gear Motor: 1. Remove wires from terminals 1 and 2 2. Use an ohmeter to check for continui

Page 40 - Breaker Cover

GEM0650/0956/1256 Remote R&R-Fan Blade and Motor Page 39 To Remove the Condenser Fan Motor Assembly: 1. Disconnect electrical power to the i

Page 41

GEM0650/0956/1256 Remote Refrigeration System Service Page 40 Refrigeration Service: General: This ice machine uses R404A refrigerant and polyo

Page 42

GEM0650/0956/1256 Remote GEM0650R Wiring Diagram Page 41 Wiring Diagram GEM0650R

Page 43

GEM0650/0956/1256 Remote GEM0956R Wiring Diagram Page 42 Wiring Diagram GEM0956R

Page 44

GEM0650/0956/1256 Remote GEM1256R Wiring Diagram Page 43 Wiring Diagram GEM1256R

Page 45 - Fan Motor

GEM0650/0956/1256Remote Freight Claim Procedure Page iii Important! Inspect Promptly This merchandise has been carefully inspected and packed in a

Page 46 - Torque Caps to 7-12 ft.-lbs

GEM0650/0956/1256 Remote Service History Page 44 What to Do Before Calling for Service: ●Check the water supply to the ice machine. The ice mac

Page 47

GEM0650/0956/1256 Remote Warranty Page iv Ice-O-Matic Parts and Labor Domestic & International Limited Warranty Mile High Equipment LLC (the

Page 48 -

GEM0650/0956/1256 Remote For the Installer Page 1 Installation Guidelines: For proper operation of the Ice-O-Matic ice machine, the following ins

Page 49 - Wiring Diagram GEM1256R

GEM0650/0956/1256 Remote For The Installer Page 2 GEM0650/0956R

Page 50

GEM0650/0956/1256 Remote For The Installer Page 3 GEM1256R

Commentaires sur ces manuels

Pas de commentaire